Guides by FreeSpirit

Well I finally got round to fitting the bull bar which involved removal of the grill etc, also a lot of cutting of the centre lower grill etc to fit the bulbar brackets, see below for steps on removal. 1st remove the headlights 2X bolts each side - 1st disconnect the wiring by sliding the grey...

Have received a few requests for the guide I wrote out for myself next time I need to do this job so here it is - I have attached some pictures but these are not in order or that good because of the limited visibility & accessibility on the Ducato. Hopefully my step by step guide will have...

Downloading & Burning 244/250 eLearn ISO CD image I have just copied this from its earlier position in the Miscellaneous Section to make it easier to find & added a link for the X250 eLearn zip file. Here are the links I have put up over time as to how to download & burn the eLearn ISO "image"...

First make sure the ignition is turned off Remove the air filter housing top. Remove the air filter element itself from the housing - this can be a tight squeeze. Remove the 3 retaining nuts at the bottom of the housing & the 2 x worm clamps from the housing to the snorkel & the engine...