After a bit of help or advice please
My 2014 doblo 1.6 jtd runs but will not Rev past 1200 it splutters and cuts out
The only fault code is P0335 RPM SENSOR - have resistance checked wiring and changed sensor from a running van. There is also a lot of white smoke on idle.
I’ve checked the timing and this is 100% correct
So abit of background - this van would not start at all, changed the fuel pressure regulator it started straight up and will tick over all day but as soon as you Rev it the engine stalls and sets fault code as above!
Any help would be appreciated I’m at my wits end with this.
My 2014 doblo 1.6 jtd runs but will not Rev past 1200 it splutters and cuts out
The only fault code is P0335 RPM SENSOR - have resistance checked wiring and changed sensor from a running van. There is also a lot of white smoke on idle.
I’ve checked the timing and this is 100% correct
So abit of background - this van would not start at all, changed the fuel pressure regulator it started straight up and will tick over all day but as soon as you Rev it the engine stalls and sets fault code as above!
Any help would be appreciated I’m at my wits end with this.
Attachments
Last edited: