Hi,

I'm new to these forums, recently bought a couple of cars from copart with one of them being a Fiat 500. Completed a front end rebuild only to realise that the gearbox release bearing is shot. I have enjoyed working on this car as they're extremely simple to work on but wish that I'd bought a better example!

So the gearbox came out on Saturday (not a fun job on a driveway) and I've got a clutch kit ready to go in. Just wondering if any one on here has the torque specs for:

- Pressure Plate
- Bell housing bolts

Or if you can point me to where I can find them? I don't have access to a workshop manual at the moment unfortunately.

Thanks in advance!

I've just come across the eLearn software in the download section of this forum - this seems to have most of the tightening torques listed so will use these.

Bell housing 60nm 44 lbft brackets 50nm 37 lbft
pressure plate bolts 15 nm 10 lbft use new bolts! manual says

Thanks buddy! Appreciate it.