Wiper motor - fitting

[jOHN]

hi im told i need to repalce my wiper motor,,

my wipers have been well slow recently and at tiems coem to a halt, ive hcnaged the relay to no avail so its the motor

now how do i fit this?

do i just need a wiper motor and nothing else? as i can get this from breaksers/

tricky job?

 

[Ozric-Al]

Front or rear?

"Doctor said to give up Keee-Babs. I said 'No, no-no'"

My Members Page
OI! Road safety nutters!! George Orwell ment '1984' to be a warning, NOT a template!

 

[Anonymous]

sorry

Front

 

[Anonymous]

any1?

 

[Ozric-Al]

Take off the wiper arms;
Remove screw covers from scuttle panel( black bit of plastic through which the wiper arm spindles come);
Remove screws and lift off scuttle panel.
Once this is off you should be able to see the motor and how to get it off / replace.
 

"Doctor said to give up Keee-Babs. I said 'No, no-no'"

My Members Page
OI! Road safety nutters!! George Orwell ment '1984' to be a warning, NOT a template!

 

[Anonymous]

wiper arms? this under the bonnet?

n00b so need help

 

[Darren]

wiper arms are the wipers......., you need to remove the wipers to get the scuttle pannel off.

 

[Anonymous]

easy job? no fiddly bits?

a wiper motor just is needed to replace no other small parts?

 

[Darren]

you need to remove the wiper arms to take of the pannel hiding the motor. If the motor was on top of the bonnet it would rust and break.

the motor is put behind plastic under the bonnet to stop it from getting wet.

it's not fiddly,

2 x wiper arms to remove

1 x plastic scuttle tray to remove

1 x motor to remove!

simples