Technical Using ePer

[ernibv]

If I enter a part number in ePER ( ex. 46529385 ), I get the necessary information about the Lambda sensor, but not the technical drawing of its location or any indication of its Category or subcategory.
Anybody know how to do this?
grtz

 

[ernibv]

OK! I just found what I was looking for using the Parts Book PDF from Wiltshire Chris. Thanks Chris!

 

[Wiltshire Chris]

You're welcome. I just checked and release 84 of ePer gives you a link to the parts page when you do a search as shown below. The forum uses release 20 which doesn't seem to have the feature. Sadly, version 84 doesn't have all the parts for the B as, when it was released in 2014, a number of them had been discontinued (as I discovered when looking at my hard top https://www.fiatforum.com/threads/hard-top-and-eper-oddity.492339/) so it's probably better that it uses release 20. I should probably redo the parts book based on release 20 rather than 84 data but I don't have a copy of that disk.

 

[ernibv]

Thanks Chris! This is pretty magnificent material. And a really simple solution to a complicated question.
I have a serious technical question, but I am going to post it seperately to the Forum.
Thanks and grtz
ER