Hi Guys,
Hope you all are well. I need some help here.
Im running the following in my car:
UT 1400 motor (original wanna keep it clean as there aint lots left)
Gotech V7 Pro ECU (The gotech that gas tge 14 and 24 pin plugs "2 seperate plugs")
Magnetti Marelli distributor with a golf sensor built in (green black and red wires coming out) - only getting one pulse light to show on ECU instead of 2.
Coil with 4 pins (2 x + and 2 x -)
Thieves tried to steal my car and messed up all the wiring under the hood trying to disable the alarm system. Now this car wont spark for nothing. I have tried everything and still no spark.
Connected up a crank sensor (has 3 wires coming out. red (insulated), yellow (insulated) and silver (bare open wire), got 2 of the green lights to pulse on the ECU but still no spark. Loaded a base map for the UT and still nothing. Played around in the settings with the MODES etc and still, no spark.
Is there anybody running an UT with a Gotech V7 Pro ECU (14 and 24 pin plugs) that can be able to assist me with the following:
~Wiring diagram for Dizzy setup or wiring diagram or crank sensor setup that includes which wires from the ECU goes example pulse wires and dizzy wires etc.
~Maybe send me a saved (after dyna) map settings for the same system that I am running just so that I can eliminate the small settings that might give me hassles just to get my car started.
I dont know what to do anymore. Really I have tried my best with everything.
Hope you all are well. I need some help here.
Im running the following in my car:
UT 1400 motor (original wanna keep it clean as there aint lots left)
Gotech V7 Pro ECU (The gotech that gas tge 14 and 24 pin plugs "2 seperate plugs")
Magnetti Marelli distributor with a golf sensor built in (green black and red wires coming out) - only getting one pulse light to show on ECU instead of 2.
Coil with 4 pins (2 x + and 2 x -)
Thieves tried to steal my car and messed up all the wiring under the hood trying to disable the alarm system. Now this car wont spark for nothing. I have tried everything and still no spark.
Connected up a crank sensor (has 3 wires coming out. red (insulated), yellow (insulated) and silver (bare open wire), got 2 of the green lights to pulse on the ECU but still no spark. Loaded a base map for the UT and still nothing. Played around in the settings with the MODES etc and still, no spark.
Is there anybody running an UT with a Gotech V7 Pro ECU (14 and 24 pin plugs) that can be able to assist me with the following:
~Wiring diagram for Dizzy setup or wiring diagram or crank sensor setup that includes which wires from the ECU goes example pulse wires and dizzy wires etc.
~Maybe send me a saved (after dyna) map settings for the same system that I am running just so that I can eliminate the small settings that might give me hassles just to get my car started.
I dont know what to do anymore. Really I have tried my best with everything.
