Panda Starter problem

Currently reading:
Panda Starter problem

King of the hill

New member
Joined
Nov 19, 2018
Messages
2
Points
2
Hi, thanks for adding me.I'm new to this so hope this is posted in the right place!
I have a 2011 panda multijet 1.3 4x4. Yesterday I tried to start it and started wouldn't engage. All lights on, full battery. After third attempt it fired up. Does this every time I stop now. An suggesthions??
Thanks
 
I have had this a few time now

I'd check if voltage is getting to the small brown wire on the starter when the key is turned

if it not its likely to be the ignition switch

I struggled on for quite awhile. One I could start by turning the key hard then very slowly releasing it

the other I had to turn the ignition on wait a few moment then turn it hard to Crank.


You can test the earth lead by putting a volt/multimeter from engine ground and the battery negative and measure the voltage drop. If when it cracking its turning over at a normal speed it unlikely.
 
Back
Top