Right then chaps im in need of a little help
my old man has a Ford Focus estate 51 plate in Colorado red (so out of anti perforation warranty and no full service history anyway we DIY it)
it has what looks to be perforation rust bubbling up on the edge of the rear offside arch (fecking ford and its material arch lining)
anyhow since its an old car (but low mileage <40K miles)
and has its second mass of rust bubbling up (the first lot on the tail gate was sorted under warranty)
Im planning to.....
use a dremal and sand/ grind it back to bare clean metal,
roughen surrounding area with p1500-p2000 grit wet and dry
use some form of rust killer/ primer (any sugestions on which to use??)
then try and source enough paint (anywhere decent who can get a good colour match) so i can mask and air brush it on
is http://www.paints4u.com/ any good?
finally blend the area with laqure
then cut it back once dry...
any tips appreciated..
thanks
my old man has a Ford Focus estate 51 plate in Colorado red (so out of anti perforation warranty and no full service history anyway we DIY it)
it has what looks to be perforation rust bubbling up on the edge of the rear offside arch (fecking ford and its material arch lining)
anyhow since its an old car (but low mileage <40K miles)
and has its second mass of rust bubbling up (the first lot on the tail gate was sorted under warranty)
Im planning to.....
use a dremal and sand/ grind it back to bare clean metal,
roughen surrounding area with p1500-p2000 grit wet and dry
use some form of rust killer/ primer (any sugestions on which to use??)
then try and source enough paint (anywhere decent who can get a good colour match) so i can mask and air brush it on
is http://www.paints4u.com/ any good?
finally blend the area with laqure
then cut it back once dry...
any tips appreciated..
thanks