Liquid Knight II
Established member
- Joined
- Sep 6, 2017
- Messages
- 735
- Points
- 171
Bit of an update.
Both inlet and exhaust base plates are done...
...who needs laser cutters anyway?
Engine mount bolts straight on.
The Idea rear gearbox mount needed the Uno rubber bush to fit the car.
But the front gearbox mount is where I get to have some fun. Bracket for the box...
...so I can either weld or weld bolts and drill holes to the Uno mount once I trial fit the engine.
This would have been done today or tomorrow but my night shift didn't end until eleven this morning and I'm doing day shift tomorrow due to a scheduling balls up.
Just as well I have a back up plan for next Tuesday eh?
Both inlet and exhaust base plates are done...
...who needs laser cutters anyway?
Engine mount bolts straight on.
The Idea rear gearbox mount needed the Uno rubber bush to fit the car.
But the front gearbox mount is where I get to have some fun. Bracket for the box...
...so I can either weld or weld bolts and drill holes to the Uno mount once I trial fit the engine.
This would have been done today or tomorrow but my night shift didn't end until eleven this morning and I'm doing day shift tomorrow due to a scheduling balls up.
Just as well I have a back up plan for next Tuesday eh?