blackscell
Member
Today, while reversing, my PAS stopped working. I checked the fault code with MES, it says c1017-11, power supply voltage sensor.
Anyone has a clue where I should start? All the pdc seems fine, no cuts etc in the wiring loom. Could it be the PDC module? I would expect MES to give an error in the PDC module and not power supply
Anyone has a clue where I should start? All the pdc seems fine, no cuts etc in the wiring loom. Could it be the PDC module? I would expect MES to give an error in the PDC module and not power supply
