General Panda 750 Progress

Currently reading:
General Panda 750 Progress

christopher watson said:
It will be a bigger job to change a selecta into a manual, than it is to weld the 750 up.


Can't see why... It's not a selecta as the gearbox is at the bottom of the garden:p Most of the work is done.

Just bolt in the whole drive train from the 750...

Jim
 
That is totally repairable Steve :) My CF was in a worst state than that when we started it :)
 
You could of course, do a bit of reshelling - get a tidy shell with flat paint with a dicky engine and a bit of transferring :D
 
e505jpy said:
I recall there's something about the exhaust... Mmmm:confused:

Aye, if you're 1242ing a Cento you need a 15mm spacer on the exhaust manifold so the downpipe will clear :)
 
Stuartl said:
"Wait till I telll ya" with the amount of effort that has gone into this, there'll be a panda going should I have to take the engine out of another one and put it in the Africar.

Now who do I know with a Panda that's handy.......

Stuart likes a challenge:p

Jim
 
Funnily enough I'm just back from seeing Sylvia. Totally convinced now that it's a fueling problem so the guys are buying in a 3 bar fuel regulator and we'll see if that sorts her out. I have to leave the stronger pump down to them to but it may be to strong.
Hopefully Sylvia will be up and going again in the next couple of weeks.
 
From this; :(

Panda_Hole_Jan_06.JPG


To this; :)

Panda.jpg
 
Steve said:
From this; :(

Panda_Hole_Jan_06.JPG


To this; :)

Panda.jpg

Aww....................no more games of peek a boo for the 750 now Steve. Did Stuart do the welding? :)
 
Back
Top