Technical Oops

Currently reading:
Technical Oops

Joined
Dec 20, 2023
Messages
302
Points
157
Location
Scotland
Sorting a bit of rust, so took out the battery tray, and got a wee surprise.

Other than the obvious, am I correct that the displaced bush is part of the clutch release mechanism?

I know it shouldn't be like this, but dafty here eased the rubber back into the joint.

Not got an educated ferret to assist, so any help appreciated.

Pics before and after.
PXL_20240203_153347667.jpg
PXL_20240203_153739832.jpg
 
Good ground to engine block 👍.

Found another oops protruding from a hole in the bulkhead behind the brake lines. Looked like a drain grommet solid with muck. Think it belongs in the hole but which way 🤔?

Could be previously knocked in rather than cleared?
PXL_20240204_152445812.jpg
PXL_20240204_152525264.jpg
 
its the duck bill drain that takes water from the scuttle panel!- it just pushes back in- the lip in the photo holds it in the hole, theres two of em one on each side! -check the other side as well!
Thanks again 👍.

Wine o'clock and really dreich here. Check tomorrow.

Which direction should the bill point and is the slot underneath 🤔?

🍷👍
 

Similar threads

Back
Top