Hi,
I have a 1.6 Dynamic, 2002 vintage. I've recently bought an OBD reader, and I can't locate where to plug it into the car !
Its the usual D type, 8x8 pins. I've looked around inside the fuse box cupboard, but I can't find a loose cable or connector on a circuit board to plug it into. On the right side of the fuses, there is a large black plastic connection, with wires coming out of the top - this looks like it should be unplugged, to plug the connector in. But ... something tells me I'm doing something wrong. It must be a stand alone connection point, I can plug into.
Where can I find it ?
On a different note, I have an OBD-DIAG diagnostic reader, which handles both the ISO and KWP 2000 protocol. I'm sure the Stilo uses ISO (I hope so !).
Regards.
I have a 1.6 Dynamic, 2002 vintage. I've recently bought an OBD reader, and I can't locate where to plug it into the car !
Its the usual D type, 8x8 pins. I've looked around inside the fuse box cupboard, but I can't find a loose cable or connector on a circuit board to plug it into. On the right side of the fuses, there is a large black plastic connection, with wires coming out of the top - this looks like it should be unplugged, to plug the connector in. But ... something tells me I'm doing something wrong. It must be a stand alone connection point, I can plug into.
Where can I find it ?
On a different note, I have an OBD-DIAG diagnostic reader, which handles both the ISO and KWP 2000 protocol. I'm sure the Stilo uses ISO (I hope so !).
Regards.