IMG_02284.JPG

Grande Punto My Grey Grande Punto Sport.

Introduction

Thought id start a new thread as ive changed lots of small things and lost track of it all, but basically im back where i started :p

this is how it is now



At the moment its on fk coilovers (which im really surprised at how well they perform) about 65mm drop all round
i think the rears need spacing about 10-15mm and then drop the front to 75/80

Went for 16's a while back but looked horrible so went back to the 17 dezent motions (looking for a trade with 15 spoke sporting wheels if anyones interessted?)

Engine is standard apart from a K&N panel filter. no point wasting money on the engine as i wont get any more power :(


Also changed alot of audio, now ive got:
Rockford Fosgate P1652-S 16.5cm Front Comps
Rockford Fosgate P400-4 Amp - Powering the speakers so i dont need a HU
and a Vibe 1600w Black air box in the boot
It now sounds very nice, quality speakers for vocals and good for bass (y) really do rate rockford stuff :)

Future Plans:
Adjust Suspension
Rear wheels Spacered
17" 15 Spoke fiat alloys

thats all, Any comments/suggestions welcome
Leather looks great, how snug of a fit were the rears? Any moddification needed?

Does anyone know if Fiat Coupe Turbo leather seats would fit in the grande without to much hassle as theres loads for sale on ebay? (Sorry if this is a bit of a thread hijack)
 
cheers guys :)
@simo1234 vxr's were a no go, the guy was very dodgy and i didnt want to loose that much money :p

@kbonnie the rears are the original seats just trimmed to match

Next on the list:
1. door cards as the company doing mine wanted £320 for them! and only 400 for the rears :s
2. small interior bits
3. Exterior work and porsche wheels on :)
 
Update! (as i promised booth :p )

done:
Porsche wheels - cost way too much! :p
Abarth Headlights
De-badged grill
Interior complete (apart from door cards)
New boot build in suede
De-wipered

Heres some photos (car is filthy!)

IMG_2048.jpg


IMG_2050.jpg


IMG_2052.jpg


IMG_2054.jpg


IMG_2056.jpg


IMG_2058.jpg


IMG_2060.jpg


IMG_2062.jpg


IMG_2066.jpg


IMG_2080.jpg


IMG_2083.jpg



To do list:
Rear camber and lower - saturday
Remove front helpers and lower - saturday
Get a full alignment
Dash wrapped in real alcantara
Wrap the back of the seats in suede
Door card trim
Parcel shelf re-trim
D1 spec gear knob - ordered
New sub
Pressed show plates painted grey
Odd little bits and then its finished! (for a while :p )

As soon as theyre done itll be ready for a few shows :)
hope you like (y)
 
Your car is b--e--aaa--utiful! very nice work dude, keep it up :).

EDIT: i wish mine was that photogenic lol.
 
thats kinda the look i had in mind for mine, but now its been done, damn my laziness lol. Your car is epic mate, no honestly now its poo hot! Im going for the vxr seats when i get my ass into gear and actually start all my plans, are they really a straight swap? any issues with airbag etc? also are rears a straight swap?
 
BodyRoxz GPS
cheers! the fronts are, dont know about airbags or rears etc
Go for that look, mines about to be split, pm me if you want anything. list is below

lukemortlock7 cheers mate, yours if you want them theyre yours :)
dont know about tints, theyre from factory



Cars going to be split over summer!

interior - all work is GREAT! no expense spared
- Alfa 147 red leather seats, all electrics working ie seat belts and airbags (mint! cost £350 to buy and fit)
- retrimmed grande punto rear seats, Perfect leather match (cost me £525)
- not got round to doing the door cards but have been quoted £150 by the guys that did my rears

Boot Build
- Selling with no speakers, just the suede build (pics to follow)

Coilovers - fk ak
- 10k old, need a set of adjuster rings for 1 front coil

Porsche twists (bought for £300 plus the work put into them)
- covered less than 100 miles!!!
- Full powder coat and diamond cut edge, done by supreme wheels in MK - £275
- Fronts, 7J. Rears 8.5J.
- Tyres are falken FK452 205-4-17 - £350 fitted with chrome valves
- coded centre caps and black and silver badges - £25
- Adapters are custom made as none does them to fit behind fiat brakes, zinc plated - cost £300
- full adapter bolts, m14 porsche bolts, m14 locking bolts

fk badgeless grill

Abarth patter headlights

i think thats everything. every part has been done to such a high standard (dads in the motortrade so have been sent to the best places)

PM me for prices or details
Wheels and interior im looking for a part ex :)
 
Back
Top