Hi, it has been said loads of times but my radiator fan is not working,
I was in slow moving traffic and the engine started to over heat.
Having a look at the car
The rad fan was seized and the 50amp maxi fuse had blown.
I have put a fan in from the scrappy (Powered up by a 12v power source and it works)
New fuse in.
The temp gauge is working ok, but when I take the wire off the sensor the fan will not kick in, I have put a wire in to short the sensor wire.
I have checked the wiring from the fan to the battery and that is fine.
I switched the 2 red relays about and still nothing (my blower fan still works)
I changed the Big black relay, one from a scrappy so not 100% sure it is a good one.
Would the temp gauge still work with a dodgy wire? any idea where the sensor wire goes? is it direct to the ecu or via the battery fuse box?
I will check the sensor wire next but any other ideas?
Thanks
Adam