Technical Misfit

[Night35]

Had a rear axile fitted 2-3 months ago.

Been clucking happening and decided to have another garage have a look. The result is the garage that put the axil on hasn't fitted it properly- too far one way. Creating the clucking.
I was so f' odd I forgot to ask this need resolved ASAP- ?

 

[DaveMcT]

The hard way is to try pulling out the pivot pin bolts. The easier way is to drop the two underbody brackets (three bolts each) and remove the whole lot. Swap the original brackets to new the axle (use white pen to mark the correct positions) and put it all back under the car. Finally tighten the two axle pins.