Technical Ignition Switch wiring harness

[DRSIK]

Hi Folks

Some nasty little scrotes tried to hotwire the mischief machine.

Luckily I bought the McCritch chip WITH immobilisation.

However they managed to damage the plugs at the back of the ignition barrel

Does anyone have some old "tails" (see pic for example - but more wire if possible) I could splice in or (even better) a location where I can purchase replacement plug kits (less joins inthe wiring)

 

[DRSIK]

Still looking...

I found these on ebay but they are cut short - I would prefer more wire after the plug (as much as possible)

Has anyone got an old bit of Seicento or Punto loom hanging about I can purchase - or (even better) a source for a new plug

I need the one ringed in red (the 3 pin one)

 

[Mike1alike]

I think you can use just the metal contacts on wires there, without plastic. See if originals are ok, if they are broke, fit new ones. And zip-tie the cable in the area to support its weight and it should work ok.

 

[DRSIK]

Hi Mike

I can - but because of the exposed nature of my dash I can occasionally dislodge the individual spade connectors.

So I was try to get it back to "stock"

 

[Mike1alike]

So I was try to get it back to "stock"

Good luck in finding the part!
Try a scrapyard, if there are any close to you.

 

[DRSIK]

Looks like I may have an offer from ebay