Technical Duologic woes

[electrictech]

I recently obtain a 2014 500L. The owner said it needed a clutch. I purchased a new Luk clutch and had a local transmission shop replaced. They assured me that they knew how to work on this car.
Now the car will move but it has two error codes.
P1D34-00 Trans gear position does learn. I have a Launch X431 and tried to clear it with no luck. I have run the relearn diagnostic part with no change. The car drove fine, I only put about 2 miles on it after the clutch swap.
Now Im getting another code P1D6B-00 Clutch 1 actuator position out of range. The car will skip the 1,3,5 gears when driving.
I'm not taking it back to the trans shop and I have a 500 L manual. I'm thinking that they did not adjust the control rod.
Is there something else for me to look at or do I have to remove the clutch assembly and check the control rod.
I really like this car, but I have read up on these transmissions and they apparently can be a bear to work on.
By the way I did not fully understand the complexity of the trans when I took ownership of the car. It's in great condition and only has 81K miles, everything works.

 

[the green vanper]

Hello,

FIATs like MultiEcuScan and appropriate adapters and not any generic code readers.

Then, there's this thread you should read:

The one and only Dualogic repair thread | FIAT 500 (2007+)

Ok, so we're had a discussion thread about dualogic issues for a few years now, and it's basically 41 pages of doom and gloom, offering little hope to new folks who come here looking for answers. So I'm starting this one to try to redress the balance. There are a few garages out there claiming...

www.fiatforum.com