I have received a Driveshaft for my 1.9 JTD stilo 115bhp, from a scrapper off ebay. But it appears that the outer cv is larger than the original and the spider joint bearings are much bigger. I was just wondering if there were different shafts to fit? As the scrapper insists that its from a stilo JTD.
General Different JTD driveshafts
- Thread starter cosso1
- Start date
Currently reading:
General Different JTD driveshafts
JTD 115's all use the same shaft and gearbox afaik. are you sure that the shaft isnt from a Mjtd 150?
Does the JTD 80 use a different shaft at all? The driveshaft supplied apparently comes from 2003 model JTD, not sure of BHP.
Also the one supplied has the part number 4630791_ The last number is unreadable, but as far as i can figure out, it is possibly a 3 or 4. So can anyone figure what car exactly this shaft actually came from?
Last edited:
Just found out via the Part Number 46307913, that the driveshaft i have been sent is from a Fiat Doblo 1.9D. Now i have also found out, that later models of the Doblo use the same drive shaft as the Stilo JTD. But could this older drive shaft fit the Stilo JTD, as i am in an argument with the seller on ebay, as to why i have been sent a Doblo shaft, but he insists, he took it from a JTD Stilo. So if the seller is telling the truth, which i see no reason why he shouldnt be, could it be possible that whoever had the car before the scrapper had it, had a faulty n/s driveshaft and took the cheaper or easier to find option of fitting a Doblo shaft part number 46307913, (which they dont use on the Stilo JTD as the quality of bearings and so on are inferior)? Just a theory.
If the part number of the drive shaft is 46307913 then it's listed for Doblo only.
Part number 46307914 is a CV joint for a Stilo JTD 115 upto VIN 00279622
Where did you get the part number from?
Part number 46307914 is a CV joint for a Stilo JTD 115 upto VIN 00279622
Where did you get the part number from?
The part number is located on a sticker around the driveshaft, but the last number isnt visible. The actual outer cv housing is quite a bit bigger than the original one on my car. Also the into cv joint ( spider joint ) doesnt have the same bearings as a stilo inner joint and the inner cv housing, again is much bigger.
