- Joined
- Jun 29, 2003
- Messages
- 747
- Points
- 151
Hello,
I just changed the front pads today as they were really low. mot is tuesday *crosses fingers*. my question is, the pads i removed were 2-3ml lower 1cm in width all across the outer edge on the friction material. i dont know if that makes sense, basically they were worn more on the outer bit. as a consequence the disk had a lip that must have worn the pad this way. it was only on the inner pad, but it was the same both sides.
what would cause this?
I just changed the front pads today as they were really low. mot is tuesday *crosses fingers*. my question is, the pads i removed were 2-3ml lower 1cm in width all across the outer edge on the friction material. i dont know if that makes sense, basically they were worn more on the outer bit. as a consequence the disk had a lip that must have worn the pad this way. it was only on the inner pad, but it was the same both sides.
what would cause this?