General 14 inch alloys on seicento sx

[Granger]

Hi everyone,

Looking to fit a set of 14 inch alloys to my 52 plate seicento sx but just wanted to know if it was possible?

The main concern I have is on clearance?

Cheers,
Matt

 

[Little_red_buzz_box]

14" alloys will fit fine with plenty of clearance on an SX, you will even have enough room to lower it a foot or two!!!

 

[Eklipze3k]

It's all about tyre choice, which also depends on the width of the alloy. Try the FAQ's and this tool http://www.alloywheels.com/tyrecalc.asp

 

[fingers99]

You should lower it. See the other thread for recommended tyre sizes, etc. Also the FAQ.

 

[beecon]

No problem at all if the wheels have a 4 x 98 PCD (std Fiat size) and have the correct offset... I think ET27 is standard.
It will look really silly without being lowered. In fact it will look a lot like my 52 plate:

And yes I have bought lowering springs and centre caps since this photo

Where In Dorset are you?

 

[Granger]

Cheers for advice guys, will have a look and see what I can do!

And I'm in Dorchester Beecon!