This post contains affiliate links which may earn a commission at no additional cost to you.
General 126 gearbox for sale
- Thread starter Franko500
- Start date
Currently reading:
General 126 gearbox for sale
OP
OP
Too far from me! otherwise i would have it, the more the merrierNot tempted yourself Sean to go with all those engines you have?
What about another engine Sean, not far away? You can never have enough engines!!!!!!
I think the seller is on this forum?
http://pages.ebay.com/link/?nav=item.view&alt=web&id=111648164053
I think the seller is on this forum?
http://pages.ebay.com/link/?nav=item.view&alt=web&id=111648164053
This post contains affiliate links which may earn a commission at no additional cost to you.
OP
OP
I cant buy any more engines either, running out of space.
I will be off to strip 3 126's tomorrow morning and therefore have another 2 engines & gearboxes.
I don't know where I am going to store it, but I cant let it go to the crusher!
I will be off to strip 3 126's tomorrow morning and therefore have another 2 engines & gearboxes.
I don't know where I am going to store it, but I cant let it go to the crusher!
126Fiat
New member
Hi do you have a 126 engine and gearbox for sale
Thanks. Joseph
This post contains affiliate links which may earn a commission at no additional cost to you.
StMarks
Member
FYI that post was placed in this thread back in 2015, and the venerable member who placed it is no longer on this forum Joseph.
126Fiat
New member
Thanks for letting me know!
the hobbler
Distinguished member
- Joined
- Jul 25, 2012
- Messages
- 4,421
- Points
- 1,112
For a 126 gearbox, give Lukasz at L.P.Garage in Sudbury (Suffolk) a shout---he often has them for sale.One has to accept that they are 2nd hand, so the condition internally is a bit 'pot-luck', but I have had 2 off him and had no problems. If you are going to fit the box to a 500, you will need to fit 25mm500 drive-shafts, and transfere the bell-housing off your 500 onto it (not a difficult job). If you are fitting a 126 engine into the car, as well as the gearbox, you will need a 126 starter (you can still use the 'wire-pull' variety) as well as dust-shield between the starter and the bell housing, the specific 3rd bolt and the brace that goes between the back of the stater and the gearbox.Why are you fitting a 126 gearbox? the 500 'box is the stronger 'box.
126Fiat
New member
Thank you very much for your advice. I have a 500 with a 126 engine and gearbox.
