- Joined
- May 1, 2014
- Messages
- 273
- Points
- 170
Dismounting here and there, I found a little bit of slack on the ball bearing situated on the long drive shaft, timing belt side (offside for you, nearside for me, or so I think).
I'm asking if it is possible to change the ball bearing only (I doubt).
You can see it from photos attached.
Or else, I think I have to change (I hope not) the whole drive shaft.
The slack seems little, so I think for now I can grease it up, but I want to be prepared .....
I'm asking if it is possible to change the ball bearing only (I doubt).
You can see it from photos attached.
Or else, I think I have to change (I hope not) the whole drive shaft.
The slack seems little, so I think for now I can grease it up, but I want to be prepared .....