DaveLiverpool
New member
- Joined
- Jul 16, 2018
- Messages
- 3
- Points
- 2
Hi, Can anyone help ?
I am in middle of replacing a CV boot on my Doblo. Have fitted new boot but am having issues with hub nut. The Elearn book i have from ebay says i should have a M22 nut with a torque setting of 70Nm and 55 degrees. the nut i received from supplier on ebay is a 22mm nut but its too small. After rootig thru bin and measuring my nut that i removed, it looks 24mm. The e-learn manual shows no variation of doblo with a 24 mm hub nut.
I have no found a 24mm nut online, would anyone have a figure for the torque setting ?
have tried downloading e-learn off here but my rar extractors won't open them.
thanks in advance
Dave
I am in middle of replacing a CV boot on my Doblo. Have fitted new boot but am having issues with hub nut. The Elearn book i have from ebay says i should have a M22 nut with a torque setting of 70Nm and 55 degrees. the nut i received from supplier on ebay is a 22mm nut but its too small. After rootig thru bin and measuring my nut that i removed, it looks 24mm. The e-learn manual shows no variation of doblo with a 24 mm hub nut.
I have no found a 24mm nut online, would anyone have a figure for the torque setting ?
have tried downloading e-learn off here but my rar extractors won't open them.
thanks in advance
Dave