Hi
I have a panda 100hp with the blue and me bluetooth and buttons on the steering wheel. Im putting a sub and 6X9s in the boot, using 2 amps. Can someone help me with a headunit that will allow me to power this and still keep the blue+me and controls on the wheel?
Thanks

Mark

i dont know if anything exists yet that would allow that.
you would need a HU that allowed control interface then an interface for the panda system.
time to start trawling through ice makers brochures

there are interfaces for this purpose but i havent seen them for a panda yet., as custard said gonna have to look around., why not keep the standard headunit and run them off that? i wouldnt remove the standard HU and just have a load of usless buttons on the dash.,

Look at top name brand head units (alpine, jvc, panasonic) there could be something in development. Price would be about £75 (rough estimate, i am aware mk1 clios cost £40 still for adapter)

Cheers for the help.
I was afraid that was going to be your answers.
The problem with running them off the standard headunit is that there is no outputs on the back to run the phono leads out of.
Cheers

Mark

OZ Seicento said:

Cheers for the help.
I was afraid that was going to be your answers.
The problem with running them off the standard headunit is that there is no outputs on the back to run the phono leads out of.
Cheers

Mark

Click to expand...

Adapters to convert the speaker wires from the back of the standard H/U into RCAs are available.

Yes I have found those now, good job cheers mate. This is only a temp fix till technology moves along and produces a headunit that does all this.
Thanks

mark

There is a cable available. But you have to order it from a company in Italy, I found it a while back as i want to change my HU in 100HP to. Will Try and find it again, Think it was £79

Mate if you can find that your a life saver

Mark