Guides by arekp
1. undo 10mm bolt
2. pull out wire harness, it is tightly jammed in so you have to work itover the humps
3. 10mm hex bit to undo the strainer; it is held in place by a rubbr washer so you need to use pliers to get leverage to pull it out
4. push in new strainer
5. tighten to 27Nm
6...
1. undo 10mm bolts holding beauty cover
2. label coil packs (1 -> 4 left to right)
3. undo 4 x 10mm bolts holding coil packs
4. undo spark plugs with a spark plug socket which has a rubber insert to allow easy removal (otherwise you need a telescopic magnet)
5. partially insert new...
I needed to replace the coolant reservoir as it was starting to leak at the seam and every few months I would need to add more coolant.
Was concerned it would just blow up one day.
This worked for me, may not work for you. Take care.
Part number: New Coolant Reservoir Radiator Expansion Tank...
This PDF has photos for all steps
If not done correctly, you will damage the engine at your own risk. This worked for me, may not work for you.
NOTE: When replacing the timing belt, connect the diagnostic tool, enter "Diagnosis active" and run the self-learning procedure.
1. Remove the...
My steps when replacing engine and gear box mounts in 1.4L 500X
1. remove engine cover: 10mm socket
2. pull off clip for air hose
3. remove air box lid by undoing 3 phillips head screws
4. pull out base of air box: 1 connector to engine mount (shown below); 2 connectors to side of car...
This is a result of many hours fiddling about, using multimeters and spare batteries, modifying settings, reading forums and asking questions.
Ultimately, very easy to do.
I take no responsibility for your outcomes. This worked for me, but your setup may be different.
1. open glove box and...
1. pull off the hub cap, there is a notch under the "500" for flat head screwdriver
2. loosen wheel nuts on front driver wheel using 17mm socket
3. lift car and support, chock up passenger rear wheel
4. remove wheel
5. undo multiple Philips head screws, pull out 1 plastic plug and unscrew 4...
FIAT 500X 1.4L REPLACING REAR PADS and ROTORS
PDF HAS PHOTOS
First wheel will take 2 hours and second 1 hour.
Wear rubber gloves and make sure there’s space and good light (headlight).
These are my steps. Yours my vary and I take no responsibility for anything whatsoever that may happen to...
FIAT 500X combo lamp assembly removal
https://parts.moparonlineparts.com/auto-parts/2016/fiat/500x/pop-trim/1-4l-l4-gas-engine/electrical-cat/headlamp-components-scat
Tools
Raise car, wheel off & place under car, personal safety
Remove the two plastic anchors by pulling out central...