- Joined
- Jun 29, 2010
- Messages
- 104
- Points
- 110
cant get 14" speedlines anywhere, is there any similiar looking alloy wheels that would fit ?
.:thanks:.
.:thanks:.
Styling speedlines?
- Thread starter cinquecentos 4 life
- Start date
Currently reading:
Styling speedlines?
OP
OP
- Joined
- Jun 29, 2010
- Messages
- 104
- Points
- 110
thanks man,but they dont ship to ireland tho
I'm sure they will, they ship to mainland Europe, I can't see ROI being an issue, send them an e-mail
thanks man,but they dont ship to ireland tho
http://www.comp.co.uk/info/termsandconditions.asp
read shipping and handling, you have to email them for prices for shipping abroad
Ash
Thery are very wide and will need wobbly bolts, but very nice wheels:
http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=120625215169&ssPageName=STRK:MEWAX:IT
http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=120625215169&ssPageName=STRK:MEWAX:IT
This post contains affiliate links which may earn a commission at no additional cost to you.
hmm, they're quite nice actually.
Might be hammertime for the arches, or you might be lucky... if you need to space them out for the suspension (I'm thinking the rear arms) then you'll be knackered.
http://www.rimsntires.com/rt_specs.jsp
btw 195/40 show no difference on the speedo on that calculator, though 195/45 are cheaper and do look just nice (not too thin so as to not look quite right on a Cinq)
Centre bore would need to be machined out a little (Cinq is 57mm I think?)
Might be hammertime for the arches, or you might be lucky... if you need to space them out for the suspension (I'm thinking the rear arms) then you'll be knackered.
http://www.rimsntires.com/rt_specs.jsp
btw 195/40 show no difference on the speedo on that calculator, though 195/45 are cheaper and do look just nice (not too thin so as to not look quite right on a Cinq)
Centre bore would need to be machined out a little (Cinq is 57mm I think?)
Attachments
Last edited:
This post contains affiliate links which may earn a commission at no additional cost to you.
need much more
Ming
you can get them machined out
What about that slightly flat bit in the 5th pic, is that just on the outer lip? Bit hard to tell.
Chances are, there may be places that would bore them out, maybe enlarge the other holes a little to remove the need for wobbly bolts and repaint/power coat them. Could be a case of "jack of all trades" though.
Hope somebody here won them as they sold for a bargain price.
They finished on a bargain price, looks like the top bidder didn't stump up in the end.http://cgi.ebay.co.uk/14-COMPOMOTIV...215169&po=LVI&ps=63&clkid=5132804306381638003
This post contains affiliate links which may earn a commission at no additional cost to you.
Oh bugger, I've just won the sodding things!
Will have to get shocks, dampers, poly brushes etc now.
Will have to get shocks, dampers, poly brushes etc now.
Yeah was very tempted at that price. Well done.
Well done mate good price
. Remeber to get the centre bored open up .And 16 wobbly bolts/nuts not gonna be cheap!
Ming
i was watching these but i spent the money on a 16v engine instead lol nice to see they are going on a cento anyway lol
