Technical Incase you were wondering

Currently reading:
Technical Incase you were wondering

Joined
Jul 8, 2005
Messages
28,510
Points
5,262
Location
on the A684
How the rear light clusters are held in...


I'm thinking my new 'bodge it' lights could be the next lexarse lights! :thumb
 

Attachments

  • DSC00024.JPG
    DSC00024.JPG
    1.5 MB · Views: 805
  • DSC00025.JPG
    DSC00025.JPG
    1.4 MB · Views: 572
  • DSC00309.JPG
    DSC00309.JPG
    1.3 MB · Views: 442
Won't suggest this as a method of removing condensation from the tail lights :D


talking of condensation, how did you remove your lights? what screws did you have to remove? im getting my new light fom dealer tomorrow and im going to change it my self, dont trust dealer :bang:
 
dealer has managed to scratch my car the last two times it has been in, and as this is site is for help why not ask someone that has done it? i can see two points for it but am sure there are more.
 
What a happened? Reversed into something?

Someone scrapped my bumper in a car park 3 days after I bought it......of course there was no note admitting blame or a £50 note under the wiper.
 
talking of condensation, how did you remove your lights? what screws did you have to remove? im getting my new light fom dealer tomorrow and im going to change it my self, dont trust dealer :bang:

Open boot. Remove screws. Pull lamp towards you to pop locating pins out of the rubber gromits. Don't pull it too hard or you'll pull the cable out!
 

Attachments

  • DSC00024.JPG
    DSC00024.JPG
    514.5 KB · Views: 492
thanks....

will have to wait till next week now as the parts dept closes at 1, why they cant tell you that on the phone i dont know :mad:
 
dealer has managed to scratch my car the last two times it has been in, and as this is site is for help why not ask someone that has done it? i can see two points for it but am sure there are more.

well I have done loads of them.....without scratching the car! Takes 2 minutes to fit & I change them in car park dont even bother bringing car into workshop.
 
well I have done loads of them.....without scratching the car! Takes 2 minutes to fit & I change them in car park dont even bother bringing car into workshop.


T im sure you have, i would have thought it would not be a hard thing to do, where is your garage located? may have to travel for a good service as my local one cant seem to offer it to me.

Please note i have not named this dealer and i have never stated that all dealer's are the same. (y)
 
Ask (in a non-cheeky manner) if you can watch the tech fit the new cluster as you have had your car damaged twice in the past while repairs have been carried out, i'm sure the garage will fully understand your request & concern.
 
T i did think about this, however after my last visit to them i dont think i will be going back, i was being serious when i asked what garage you worked at, i dont mind traveling for good customer service.
 
Back
Top