Stuart2803
New member
New here so first post, I have a 2013 1.3 and i had a leak on coolant pipe going into block behind oil cooler.
Had to strip front of van down to get access , finished but now van wont start, turns over but nothing.
I didnt really strip anything down that I thought would cause issues starting, maf sensor and pipes and radiator etc, disconnected sensors from exhaust and the bottom one(which i think is dpf pressure sensor) nut broke so maybe not getting a good seal now, but wasnt sure if that would stop it starting. Did notice this plug ,(2 pin) but can't see where it goes so not sure now if it's spare and always been there or have I unplugged it. I noticed the engine management light is on but I can't mind does it disappear after van turns over or is it actually on , my generic code reader isn't showing any codes but thats not saying there isn't any there.
Any help appreciated . Thanks
