Hi all, i'm just fitting an oil pump/filter sandwich plate for the pressure/temp sender units... please can someone confirm the oil filter thread... is it M20?
Cheers, John
Cheers, John
Technical Oil Filter Thread
- Thread starter nitrane.co.uk
- Start date
Currently reading:
Technical Oil Filter Thread
Yes it is M20
when I fitted the filter sandwich plate I had to switch to a R5GT filter, it was the only one that would fit
when I fitted the filter sandwich plate I had to switch to a R5GT filter, it was the only one that would fit
M20 x 1.50 (although I doubt anyone does them in another pitch).
I think the title should actually be
Oil Filter Thread Thread.
Cheers
D
Oil Filter Thread Thread.
Cheers
D
OP
OP
Make that the Oil Filter Thread Thread Ex-Thread (it has ceased to exist...)
All sorted now.
Cheers, John
old thread, but im guessing M20 is not the same as 3/4 UNF? 
old thread, but im guessing M20 is not the same as 3/4 UNF?
I've not got my little book to hand, but can't see it being the same -- or even sameish enough in this application. What you trying to do?
nope its not teh same
The takeoff plate (well blanking plate for the takeoff plate) is a 3/4 UNF fitment, starts to grip but then by looks of it is going to eat the filter thread
Think im going to have to find out if they do a M20 x 1.5 blanking plate
The takeoff plate (well blanking plate for the takeoff plate) is a 3/4 UNF fitment, starts to grip but then by looks of it is going to eat the filter thread
Think im going to have to find out if they do a M20 x 1.5 blanking plate
Depending on the usual "wot'll it cost" factor, see if the filter thread is actually removable: I'm guessing it'll be a sort of hollow stud, threaded both ends. Depending on who you know, you could maybe get one turned up 3/4" UNF one end, whatever it is the other.
