Technical I m making a TIPO engine

Currently reading:
Technical I m making a TIPO engine

yakoo

New member
Joined
Nov 18, 2006
Messages
12
Points
2
hi everybody

i m a student in technical universty at automative engineering

name of a lesson is "engine design". We make a engine design and simulation it in this lesson.
i wanted to make Tipo 1.6 8v . For this reason i need all of Tipo's measurements.
piston and piston ring measurements
piston pins measurements
crankshaft measurements
camshaft measurements
valves(intake-exhaust) measurements
flywheel

If i have this measurements i will make tipo's engine and simulation it and then share it with all of members.

pls help me in this subject
it ll be(y) very exciting
 
hi everybody
i m looking for flywheel diameter

are there anybody know it?_
 
Hi would love to help unfortunatley mine is only a 1.4, but you can have a look at mine and figure out what is wrong with it! (other than a dodgy battery!) If you need measurements i can get them for you but not sure they be any use because of the engine size difference!!:)
 
hi
my friend tipo 1.4 and 1.6 have a same flywheel diameter so pls send me to your measurement.
i m waiting you
thanks from now
 
Hi!

I would also prefer designing a Sedici engine and unfortunatly I don't have the exact diameter of the flywheel. Would it be precise enough for you to rescale it out of a cutout section?
I can give you the techn data pages of service manual (german) if you like.
Shows the most important measures.

By the way, I also did this kind of lesson on my University, so I would be interested in the results. Which software do you use?

Regards, Didi.
 
i m happy to take a this kind of lesson on your university. I use programme written at "visual basic" . İ enter to it peak rpm, max power , swept volume and compression ratio and then click calculating button and finally it calculate "piston-gudgeon pin-connection rod-crankshaft-inlet,exhaust camshaft-inlet ,exhaust valve coil-inlet ,exhaust valve and flywheel " measurements.

But you know every automative manufactering use different bore/stroke ratio and etc value on its cars. For this reason i need some measurements . for example flywheel diameter , valve lenght . if you have them pls send me.

altought i study to transfer to stuttgart universty in these day with Erasmus programme. İ hope it can be .
anyway i m waiting your news . Pls hurry up because i will deliver this project to teacher on this tuesday.

my e mail address : [email protected]
 
Hi!

Sorry to be late.
Now I got it - thought you would do constructive lesson not calculation.
My data sheets do not contain either flywheel dim or valve lenght - sure you meen lenght not stoke?

Regards Didi.
 
anyway
thanks also again . İ delivered my project.
 
hi eveybody

my project will finish in recent time and i will share with you. animation of tipo 1.6 8 valves a engine is waiting for you. pls get a inventor programme
cos you will need see when it is working.

coming soon :)
 
sorry everybody you dont need a inventor programme to wiev it.
 
Back
Top