Technical How to change settings to show mph on screen digitally

[Kalybell]

Hello, I have just received my new 1.4 500X Cross model, it is possible to get the MPH on the screen as I cant seem to find the settings how to get it to show like it was on my little 500.

Can anyone help as its driving my patience

Would appreciate any help?

 

[s130]

When you have the Digital Speedo visible then if you press the main OK button on the steering wheel (left side central) then the speedo with change from km to mph and back to km on each long press.

 

[twobigdogs]

Just use left and right buttons and up and down buttons to cycle through the various displays to show digital speedo. As above if you want to change from KMh to Mph.

 

[GarryH]

Just went out to the garage to check how it works on mine. This is what I did -
1. Started the engine with digital speedo showing in the center binnacle.
2. Used the left or right buttons (on left-side of steering wheel) to change what was displayed in the centre binnacle.
3 Used the buttons on the steering wheel again to revert to displaying the digital speedo in the centre binnacle.
4. You then have about 5 seconds to push the OK button to change from kph to mph or vice versa. During that 5 secs there is an instruction to do so that appears at the bottom of the central "speedo" binnacle.

 

[Mikehep]

When digital speedo in central binnacle, press of OK changes mph to kph. A further press of OK goes back to mph. No need to do this within 5 seconds

 

[GarryH]

Quite correct! Turns out it is only the reminder instruction (to press the OK button) that lasts for 5 secs.