Hello

Currently reading:
Hello

SPW

New member
Joined
Mar 13, 2008
Messages
8
Points
3
Location
Glos, England
This is a mail from SPW,s husband as she has a few questions and I am asking them as I wrote of her last Punto a 16V ELX :eek:

car.jpg



We have just bought another one more or less same spec 02 16V ELX. This one does not have the alloys as the last one had, I can get hold of some from a R reg 1.2 Punto (14 inch, 5.5J rim width,4 stud, 185 tyre width),but have to drive to get them any one know if they will fit the 02 Punto?

Andrew.
 
Last edited:
How did you managed to do that?
A long (ish) story, I normally go to work on my bike (Kawasaki 750 zephyr) I also have a car (Sintra CD2.2)but on the morning of the accident it was very heavy rain so I decided to take a car. The first car in the drive available to get out was the Punto so I took that (as I had done in the past). Driving down a hill I hit heavy deep mud from farm traffic and slid into a bank this had a slight camber and that was enough to flip it on to its side (all at low speed). I had to climb out the sun roof £3200 worth of damage so it was written off.

Sue was very fond of her car so I am doing my best to make the new one as much the same as the old one.


Andrew.
 
Last edited:
Yes I was Ok not a scratch (y)

Just hope some one knows about the tyres:

This one does not have the alloys as the last one had, I can get hold of some from a R reg 1.2 Punto (14 inch, 5.5J rim width,4 stud, 185 tyre width),but have to drive to get them any one know if they will fit the 02 Punto?

Andrew.
 
Hello and welcome to the forum (y) you are best asking that question in punto technical ..you will get a quicker response (y)
 
Back
Top