Fitting A JVC Cd Player

[danhough]

hi, i just registered and needing some advice

i own a fiat punto 1.2 54 plate

and im trying to install a JVC cd player, ive connected up the power, but all it seems to say is EJECT DISK, thats the only button which works

ive searchd previous threads about connecting the red and yellow together, but none of my wires are solid yellow or red, they seemed to be a mixture or colours

any help would be grateful

thanks

regards

dan

 

[volxstu]

Hi welcome to the Forum :wave:
They should be a solid colour on the Aftermarket Units wiring loom. If not try and take as high res pic of the loom as possible and post it here and i will mark it up for you.

 

[Harvz]

do you have a green and blue cable and a red and white cable in the power block?

If so, buy a standard iso loom from halfords, make sure the red cable on your loom is where the red and white cable would go, if not, stick a pin down the connector on your loom, and it should pop out, and then put it back in the correct hole.

Then join the red and yellow cables on your loom either by soldering them together. (i used a caravan connector for time). And then your loom in the car iso, and then your loom into the back of the stereo. AND VOILAAAAA, it should work

This saves you cutting your original fiat power cables etc .

If it doesnt work. Please PM me

ANDYY.