Technical Clutch bleed in 2018 ROBOTIZED GEARBOX M40

Currently reading:
Technical Clutch bleed in 2018 ROBOTIZED GEARBOX M40

Pawlosamigoss

New member
Joined
Oct 26, 2022
Messages
1
Points
1
Location
Grimstad
Hello everyone.
I have a little bit problem with bleading the clutch in robotized m40 manual gearbox. Can someone please let me know how to fix that problem?
I changed fly wheel and clutch because pusher was damadged. Car came on a lorry. I have connection to witech fiat platform and elearn and there i cannot find anything. I already changed everything and mounted back gearbox back on car but for me its not possible to mace clutch bleed. master slave unit dont give me dot4. only some very very very little drops nearly like nothing. I dont know whats procedure or gateway fix of the problem and as well I have no fault codes here from ECU or TCM please help guys im very stuck with that job !!

Here I found gearbox description https://manualzz.com/doc/6391849/robotized-gearbox-m40
 
Hi

The Ducato Robotised gearbox is known in English speaking markets as Comfort Matic or Comfortmatic. The controller ECU is the Magneti Marelli "Selespeed" CFC348.

The clutch fluid (Dot4) shares the same reservoir as the brake fluid. The actuator fluid (ATF) is separate.

I believe you need a diagnostic tool to bleed the clutch, and then to calibrate the clutch "bite point". Fiat use a tool called "Examiner". For the home user I recommend "MultiECUScan". You will have to double check that this software can carry out these operations. A package will have both Software and Hardware adaptor cables. The cost in the UK is about £125. (1500 Krone). A 2018 vehicle may also need a security gateway bypass cable.

See: https://www.gendan.co.uk/multiecusc...4nNP2B0rubpi_tjLo6NoLiROZ6h8AyDhoCQRUQAvD_BwE
 
Back
Top