Hi there,
I have an 'end of line configuration incorrect' fault in my EPS although fully operational, it is flashing the fault light and reading fault code C1214-55.
This started after performing a proxy-alignment as the car had previously had components swapped (stereo) but I am unable to clear - any thoughts please?
I feel that I must have changed a setting within the proxy alignment to cause the above but am unable to locate an option that seems to have a bearing on it. EPS is working fine, just flashes up on the dash board.
Any thoughts greatly appreciated
I have an 'end of line configuration incorrect' fault in my EPS although fully operational, it is flashing the fault light and reading fault code C1214-55.
This started after performing a proxy-alignment as the car had previously had components swapped (stereo) but I am unable to clear - any thoughts please?
I feel that I must have changed a setting within the proxy alignment to cause the above but am unable to locate an option that seems to have a bearing on it. EPS is working fine, just flashes up on the dash board.
Any thoughts greatly appreciated