Hello,
I fitted new slave cilinder and now I can't bleed the clutch... i have tried basic method (2 people, one pressing and holding the pedal, other one opening and closing bleeder).
I also disconnected the hose going to slave cilynder, mate pressed the pedal and hold it all the way in till I connected hose. There was no visible air in the hose...
Pedal is returning normaly...
What else can I try?

When I was bleeding old cilynder it was bleeding ok. But on new one sometimes little bit of fluid comes out and sometimes nothi g.

I tried gravity bleeding method, there was alot of bubbles in the fluid at first and no bubbles at the end and clutch is still not working, pedal is returning normaly but it's too soft. Should I suspect master cylinder?