OK - can anyone with a circa 2000-2005 car (any type) have a quick look at both the driver and passenger front seats for me and tell me the spacing between the seat mounting bolts please?

I'm looking for a pair of singles (non-airbag) for my Scudo and want to see what sort of things will fit.

If you could let me know the spacing between centres (of the bolts) front to back and side to side, that would be great - and if you could also say whether the seats you have are one piece of have seperate bases, that would also be appreciated!

Cheers

Anyone???

Did you find out if any fitted??

Nope - one day I guess I'll have a trawl around the scrappies and check myself.....

Right had a look at the scrappy today got a set of 806 seats with swivel plates passenger fitted now all lined up OK apart from 2 of the hole in the new seat frame were to small for the bolt to go though and need drilling out but fine apart from that

Any chance of a pic or two? Either on here, or email me at [email protected]

Also - how much did they cost you, out of interest????

Cheers

All done now just want to keep an eye out for a better set of seat and mount them on the swivel plate.

The driver seat in the lowest position is a bit higher than the standard seat.

wont let me put the images in the post as i have less than 5 posts there in the gallery though.

now that's 5

Good job!!

Are the subframes able to be seperated from the seats?

If so, are the tops of them flat?

Do they all have the swivels??

Might go and find a set of these and see what can be done in terms of different seats - maybe something off an Alfa?????

The seats have what looks like 6 torxs hold them on on looking to the subframes which is part 4 on the diagram not undone these myself yet though.

Not all 806, synergie or Ulysses have the swivel plates on them. I like the sound of the alfa seats though mite have a look at that myself.

Part 2 is the base on the van - fits to part 7. I was thinking of splitting from one of these parts and fitting another seat - but it depends on the bolt pattern......

Good job!