So I have just purchased these on eBay -
TEAM DYNAMICS WHEELS

PRO RACE 1.2

(SET OF 4)

15x7.0J e35 4x98 58.1
Can anyone tell me if I need anything else to fit them to a 100hp? Wheel bolts/spacers/spigot rings?

Also what tyre sizes can I choose from?

All help appreciated

Sounds like they're ready to fit. 195/45 is your best shot, or if you want comfort you can go up a size in profile but let your insurance company know of course.

Awesome thanks mate, im on 50 for profile at the minute I believe, any chance I can use the same tyres? Also same question for bolts?

Yeah you can use the same tyres As for the bolts that would be a question for team dynamics but they will probably be the same

Winner, thanks mate that's a great help (Y)

The alloys should gone with spigot rings etc. just check if the TD's have a tapered or flat bolt hole as if they are flat (which I don't think they are) you'll need a new set.

If it was me, I'd pick up a set of tuner bolts as they will look better than the normal fiats bolts

The 58,1 is spot on, so no spigotrings. Bolts needed can differ in length and pattern (tapered or round tapered).

gr J

Thanks guys think I will be picking up a set of black tuner bolts rather than my rusty fiat ones!

MattV said:

Thanks guys think I will be picking up a set of black tuner bolts rather than my rusty fiat ones!

Click to expand...

Let me know where they're from and how much please. Mine want binning.

Rang the company selling the wheels earlier and they actually provide a free fitting kit which includes bolts! They may not be anything special but they will do the job for now

AB100 said:

Let me know where they're from and how much please. Mine want binning.

Click to expand...

You can get tuner bolts on eBay for not a lot and in various colours!

Seller contacted me yesterday and said I will need 5mm spacers as the wheels are et35 anyone know if this is true?

MattV said:

Seller contacted me yesterday and said I will need 5mm spacers as the wheels are et35 anyone know if this is true?

Click to expand...

I would say so yes. Mainly because your wheels are wider.


Basically, the standard 100hp wheel is 6.5x15 ET30.


the wheels you have are ET35, so their hub face is 5mm closer to outside rim meaning the wheel sits closer inside the arch. Couple that with the wheel also being 6mm wider on each side and your inner rim will be sticking inside 11mm closer than the standard 100hp wheel. You'll need at least 5mm spacer to cover this.


I have the Punto 6.5x15ET35 wheels on mine and they just fit - the offside rear being rather close.

:yeahthat:

http://www.1010tires.com/Tools/Wheel-Offset-Calculator#Results

I'd say spacers of 10 mm because they have their own centrering.

gr J

I concur

Can any one tell me the length of standard panda wheel bolts?

I know it's a daft suggestion but just take one out of your car, you don't need to jack it up if you're just taking one off

I would ideally but I don't have it in the garage for bumper repainting

IIRC 22mm thread.

gr J

You are right, 22mm thread length so with 10mm spacers i have worked out (with some great maths ) I need 32mm bolts however can't seem to find the right length and size or tuner bolts. Any help appreciated once again!