Hi. I am working on my Panda "Colour" and mine seems to be well - represented in terms of common Panda rust and rot spots!
I am working on the back of the driver's side sill, near the mounting for the suspension arm. Because there is damage to both sides I don't have a reference of how this should lookonce fixed.
Does anybody have a decent image of this area that has either been repaired (or if you were lucky never needed it!)?
This is mine attached.
Also, I am guessing that it is best to take the whole of the fuel tank off to weld this area safely. Or could you just take the filler and breather off and seal up the the tank?
Any advice very gratefully rceived.

Yup, that's the bit I've been putting off for about 18 months now. I took the tank and rear axle off for better access round it but have now got distracted and haven't actually tackled it yet

It actually looks about right i think. Looks better than mine did b4 welding

Filler pipe collar for when you break it getting the filler pipe out of the way:
https://www.ebay.co.uk/itm/Fiat-Pan...e=STRK:MEBIDX:IT&_trksid=p2060353.m1438.l9372