Technical Pandas reunited, my old Fizz.
- Thread starter VmanC
- Start date
Currently reading:
Technical Pandas reunited, my old Fizz.
OP
OP
Sounds like you should go to a different mot station!
The flowers look good...what I would add to the rear window and the window screen would be a large Animal or a similar surf company sticker...I've seen these stickers with the same flower so would tie in nice I think...
I'm hoping to recieve some stickers today that are similar to what you describe Kev, but a little more personalised
. Pics, of course, when they're on.
bad earth on the fan throwing engine sensor readings out???....maybe?
....maybe?
OP
OP
bad earth on the fan throwing engine sensor readings out???....maybe?
Worth checking Andrew, cheers.
The flowers look good...what I would add to the rear window and the window screen would be a large Animal or a similar surf company sticker...I've seen these stickers with the same flower so would tie in nice I think...
Not quite what you were suggesting Kev but I wanted to get my company name in there somewhere..........
Ideally I'd have wanted to have a limited co. ( Limited editions unlimited ltd )
, but they won't let you have unlimited in the name of a registered co.
Nice
Very girly
Very girly
OP
OP
Delivered car back to Jessica yesterday .
Sorted out the emissions on Monday by swapping parts from Sparky ( LukeP's old clx) until something made an improvement. LukeP was there to help too, cheers Luke, must have been nice to get your hands on Sparky again. The third thing we swapped was the lambda sensor and it was this that improved the running, much smoother, so I decided that it was ready for re-test. Went straight through with co on 0.6% .
Once the mot was cracked I turned to the final job, noisy speedo cable. Throughout my two years owning this car I was unaware of this being a common problem, always thinking the gearbox bearings were knackered. Still wasn't sure it was only the speedo cable this time as the noise was so bad, but that is all it was. After removing the inner cable, washing it off with WD40, then re-greasing it as I fed it back in, silence was restored.
Quite alot of work this year, so I hope Jessica gets a trouble free run for a while.
.Sorted out the emissions on Monday by swapping parts from Sparky ( LukeP's old clx) until something made an improvement. LukeP was there to help too, cheers Luke
, must have been nice to get your hands on Sparky again. The third thing we swapped was the lambda sensor and it was this that improved the running, much smoother, so I decided that it was ready for re-test. Went straight through with co on 0.6% .Once the mot was cracked I turned to the final job, noisy speedo cable. Throughout my two years owning this car I was unaware of this being a common problem, always thinking the gearbox bearings were knackered. Still wasn't sure it was only the speedo cable this time as the noise was so bad
, but that is all it was. After removing the inner cable, washing it off with WD40, then re-greasing it as I fed it back in, silence was restored.Quite alot of work this year, so I hope Jessica gets a trouble free run for a while
.
