chris3234

Is it not near the gearbox just before the end where it goes from the cables to the ball and socket type fitting?

Just There's normally a quarter turn nut under the bleed niple on the slave cylinder All-through that dosnt look like there is...

See if you can get hands on a Gunsons easy bleed kit. Not expensive but very very helpful. It used air pressure to assist which helps...

Yes and yes Bless from far to the nearest I'd do the clutch last of all it can be a bit tricky to bleed

Only if serviced by a main dealer Fiat dosnt have any sort of online service database

Depends if it was fully Fiat dealer serviced all its life? if so ,maybe!- but if not then theres a string of independents out there...

What brand was the rear shocks? Seen reports of some having the wrong size holes for the mounting bolts so the shock wasn't tight...

I have that US date format in a database programme I use (Windows) drives me nuts, can’t get the UK date format, even if I change to the...

So in Canadian Temps that would be around 1/2 the summer range

well, knock me down with a 10 ton truck. I did not expect that. If that is the case the Actual Fiat software is quite prescriptive (not...

This is probably the best trim restorer I've used last a long time 6 months + and still haha good finish Just be careful to avoid...

You could try this stuff - did work really well on the stone chip protectors on my Cinquecento Sporting...

Hello, I think that someone would be able to help, but there's not a single information about the car model and year... ;)

This is what I suspect older corroded connection and earth points, I've considered trying running a temporary new earth and feed to test...

I wonder if some of the people with bad lights just have poor voltage to the bulbs Would be interesting to see some volt meter readings