i have taken my gBox out of the 1108 seicento and i am putting a new box in it, i have taken the driveshafts out but there still is the two black cv joint holders as such still in the gear box, does any one know how to remove these, i esume bit of a lever have tryed to pull but theres only a little play?

cheers all

Big screwdriver behind then and lever them out. Its getting the circlip out of its groove that presents the difficulty from what I recall.

Careful not to crack the G/B casing

Two levers 180 degrees apart, tape a piece of scrap to the diff housing to bear against, unless you have three hands.

Cheers

SPD