Hi,
is there any possibility to deactivate the lamp check for a facelift model?
It really sucks, that you always need load resistors in case you change for LEDs....
Perhaps via service tool?
I replaced for example the fog light by a second reverse light, for having a symmetric look and installed there a red LED, that it shines red. Even for this you need a load resistor...
is there any possibility to deactivate the lamp check for a facelift model?
It really sucks, that you always need load resistors in case you change for LEDs....
Perhaps via service tool?
I replaced for example the fog light by a second reverse light, for having a symmetric look and installed there a red LED, that it shines red. Even for this you need a load resistor...