Just to remind my case that i had brand new axle shafts but new spacers was impossible to crash, they where stronger than axle thread so i turned them down little by little on my lathe until i got the desire length and finally correct torque.
I cannot seem to find spare clips that go in the bearings ?
Anyone know where to source them, I was getting the other items from AG.
I may be able to use the one that are in situ, but thought I would be prepared with spares.
Damian from this forum had send me a file with instructions if it is ok with him i can send it to you.
Thomas
Hi Thomas,
Not the cotter pins, in the following picture, from the left , there is 22005, 20011, " split ring" 20005.
Darryl
I will send you later Damians file, do you also have Haynes manual?
Hi Thomas,
Just checking if you had a chance to send that file, thanks
Darryl
Hi Thomas,
Just checking if you had a chance to send that file, thanks
Darryl