- Joined
- Apr 4, 2014
- Messages
- 15
- Points
- 60
I'm struggling to find a solution to a lumpy idle on my 100HP.
Connected it up to multiecuscan - no errors.
Searched the forum and got a few pointers.
(The spark plugs, air filter and oil all recent - though the poor idle arrived before this service)
Checked all the air lines / vacuum. All OK.
Checked all plugs / connectors were secure. So far so good.
Back to the forum!
One post mentioned cleaning the throttle.
Most of my previous cars have been sensor overload - this little Panda though has me stumped. Other than one electrical connector on the throttle body itself - I've not found any MAF or intake sensor. So really all I've done is clean the butterfly valve in the throttle... Seems like I'm missing something?
Any help at this point would be hugely appreciated!
Thanks
Connected it up to multiecuscan - no errors.
Searched the forum and got a few pointers.
(The spark plugs, air filter and oil all recent - though the poor idle arrived before this service)
Checked all the air lines / vacuum. All OK.
Checked all plugs / connectors were secure. So far so good.
Back to the forum!
One post mentioned cleaning the throttle.
Most of my previous cars have been sensor overload - this little Panda though has me stumped. Other than one electrical connector on the throttle body itself - I've not found any MAF or intake sensor. So really all I've done is clean the butterfly valve in the throttle... Seems like I'm missing something?
Any help at this point would be hugely appreciated!
Thanks