R

RobR

New member

Joined

Feb 13, 2007

Messages

7

Points

4

• Feb 13, 2007

• #1

Hi,

First time poster so be gentle.

I own a 2004 Ulysse 2.0 JTD Dynamic, the rear washer has stopped working, the motor runs and water must be being pumped as the driver side floor is soaked and smells of washer fluid.

But I'm unable to find were the water is coming from, I presume a pipe has come off but where is it? Does anyone know where to look?

Thanks

Rob

 

Pat H

Member

Joined

Jan 31, 2005

Messages

385

Points

83

Location

Hertfordshire

• Feb 13, 2007

• #2

I think it goes up the driver side rear pillar. Theres a join in there that pops open if the rear washer is frozen and you use the pump. It then sprays all over the electrics in there. Theres a panel that unclips but the join is a bugger to reach as it's about level with the rear boot lamp.

 

OP

OP

R

RobR

New member

Joined

Feb 13, 2007

Messages

7

Points

4

• Feb 13, 2007

• #3

Thanks for the pointer, I incorrectly thought this was at the front of the car as this is where I noticed it was wet, however I've just been and checked the rear of the car and that is wet. So it must be running from the back to the front, I will look for the joint in the rear when it's light.

Thanks

Rob

 

T14086

Patron member

Written a guide

Joined

Sep 12, 2004

Messages

39,826

Points

7,251

Location

Preston

• Feb 13, 2007

• #4

Join is just above the access panel,reach up & its there.....you will probably have to order up a new parking module aswell as its probably soaked in water & as its on the CAN network it can/does pay havoc with the reset of the vehicles CAN system.

 

OP

OP

R

RobR

New member

Joined

Feb 13, 2007

Messages

7

Points

4

• Feb 14, 2007

• #5

Found it!!! Reconnected now OK, lesson learnt, don't operate the rear washer if frozen.

Thanks All.

Rob