ON1ANZ
New member
Dear Panda Enthusiasts,
I am the proud owner of a Panda 4x4 (model 141 1984 965ccm 35KW 99.000 km).
I have already repaired the ignition coil and its cables, both driveshafts, windshield washers, and other minor issues.
However, I still have the following questions about how to improve this car:
1. Is there a trick to prevent the gear lever from constantly coming loose from the round plastic anchoring piece?
2. Does anyone have DXF drawings of all the interior trim so I can mill them?
3. Where is the MAP sensor located on the engine? ( picture is oké) My engine stops always when I stop the car. I can restart the engine with no problem. Someone told me that it will be probably this sensor.
I'm already looking forward to some answers or extra questions.
Help me convince my wife that my Panda wasn't a bad buy...
I am located in Belgium.
Kind regards.
Nik Vankerckhoven
I am the proud owner of a Panda 4x4 (model 141 1984 965ccm 35KW 99.000 km).
I have already repaired the ignition coil and its cables, both driveshafts, windshield washers, and other minor issues.
However, I still have the following questions about how to improve this car:
1. Is there a trick to prevent the gear lever from constantly coming loose from the round plastic anchoring piece?
2. Does anyone have DXF drawings of all the interior trim so I can mill them?
3. Where is the MAP sensor located on the engine? ( picture is oké) My engine stops always when I stop the car. I can restart the engine with no problem. Someone told me that it will be probably this sensor.
I'm already looking forward to some answers or extra questions.
Help me convince my wife that my Panda wasn't a bad buy...
I am located in Belgium.
Kind regards.
Nik Vankerckhoven
