Technical Fuze blowing

[Steady1234]

Hi all , I have a Peugeot boxer 2014 , ( technically a fiat ) it blew a fuze F17 and it went into limp mode, changed fuze and all ok again? Couple of weeks later blew fuze again, changed fuze and all ok again till yesterday, blew the fuze again and now when I try to replace it blows immediately, have unplugged everything I can think of but it still blows? Have unplugged both engine looms from the ecu but it still blows, fitted a different fuzebox although it wasn’t identical but still blows, have disconnected bcm no difference, any advice greatly appreciated
Cheers

 

[Greasytrucker]

Erm, haven’t you already asked this question in a different thread? You have replies in the original thread

 

[Steady1234]

Erm, haven’t you already asked this question in a different thread? You have replies in the original thread

Yes I have, but thought posting again might get more answers?
Thanks for your reply, I have today had the fuzebox out / ecu/bumper corner of so I could check all the wiring, no damage to any of the wiring, I’m a bit lost, I suppose I’ll have to get an electrician to look at it , I’ve looked up what f17 does but get lots of different info in what it feeds,

 

[Greasytrucker]

Yes I have, but thought posting again might get more answers?
Thanks for your reply, I have today had the fuzebox out / ecu/bumper corner of so I could check all the wiring, no damage to any of the wiring, I’m a bit lost, I suppose I’ll have to get an electrician to look at it , I’ve looked up what f17 does but get lots of different info in what it feeds,

Right ok. If you post what you’ve done in the original thread it then rules these things out and you may get some new suggestions. Multiple threads for the same problem usually just leads to confusion thats all

 

[Mike1alike]

Is there a relay on the fuze that blows circuit? Did you take a look on it?