Technical Doblo Cargo Bump Stop Removal

Currently reading:
Technical Doblo Cargo Bump Stop Removal

spooncoot

New member
Joined
Jul 7, 2014
Messages
8
Points
4
Hello all I've just joined so please be gentle ;)

My 52 plate doblo cargo needs new bump stops/spring assisters/wicks , whatever they're called :confused:

I've ordered 2 of these ( 271222894553 ) from ebay and am expecting them on Wednesday.

I've looked at the existing ones and I'm not sure how to remove them.Is it just a case of putting something like a cold chisel or large screwdriver in the slots and tapping them round clockwise, or is there more to it than that ?

I was hoping they would just tap round an loosen up so I could then unscrew them.

Any advice for me please ?
 
They unscrew when new come you will see, old ones look like a bad hair day ?
rolleyes.gif
 
Last edited:
Thanks for that 500e.

Yes they did just unscrew.Took off the wheel on each side and tapped them round with a chisel, then unscrewed them.

Yes they did look a bit of a mess, about half their original size too.
 
Only 1/2 their original thats like nearly new :D how low is the back
 
Back
Top